2 Point Straight Side Press (SLX Series)

The Stamtec SLX double crank frame press was designed for stamping large parts, or parts produced in long progressive dies, that require deeper or more complex forming, at high single stroking rates or in continuous mode, using either blanks or coil stock. The GTX offers an extra wide, centered 6-pt, full length box gib type.

This press is different from others in that Stamtec’s Link Motion Drive technology is standard on the SLX series. With link motion, the slide velocity decreases by up to 40% during the working portion of the stroke, so the material flows more effectively, while the non-working portion of the stroke increases by an offsetting amount to maintain high production rates. The result is a better quality part at higher production rates. In addition, slower speed through the working stroke reduces die impact, punch penetration, snap-through, noise, and vibration, thereby increasing machine and die life.

Tonnage Range: 176-550 with Link Motion

Press Advantages
With the SLX 2 point press, hydraulic overload protection is standard. As an added benefit, if unequal loading is applied across the slide, the overload system applies full pressure where required to help maintain parallelism.

Fast response hydraulic overload relieves the pressure of a tonnage overload in milliseconds, stopping the press immediately. Hydraulic pressure is restored with the press of a button. Normal operation is resumed after the press is inched to TDC. Your press and dies are effectively protected!

Link motion drive design reduces slide speed in the working stroke by 40%, prolonging tool life and reducing noise and vibration. Keep the same parts per minute production rate with a slower speed when working the material.

Standard Features
Link motion drive technology
Wet type clutch and brake
Flywheel brake
Hydraulic overload system
Air counterbalance system
Automatic grease lubrication system
Digital die height indicator
Removable, flanged, t-slotted slide plate and bolster
Motorized slide adjustment
Press control with:
Six (6) programmable limit switches
Four (4) programmable die monitor inputs
6-digit part & batch counters
LCD display screen for status and fault messages
LED display for crank angle and spm
Interlocked die safety block

Optional Features
Press controls from industry leaders like Wintriss, Link, Helm (Allen-Bradley), Toledo (Allen-Bradley), Siemens, Mitsubishi, etc.
Anti-vibration press leveling mounts
Safety light curtains
Tonnage monitor
Quick die change system
Die cushion
Knockout bar
Compact servo feedline

Press Components
1. Slide
2. Adjusting screw
3. Front timing gear
4. Crankshaft bearing (front)
5. Connecting rod
6. Crankshaft
7. Main gear (rear drive)
8. Link
9. Lever
10. Flywheel
11. Clutch & brake (wet)
12. Pinion gear

**Please contact us for: SLX Specifications


[ Back ]


Last update 7/08