2012 WARDJET RX-2015 WATERJET CUTTER
Specifications
- Remote Pump ON/OFF, Turn pump on and off from the controller, switch between high and low pressure
- Pump Voltage Change (208-230)New A-6030 or AS-6050 only
- Tie in low level sensor to controller; stop machine and give warning at controller
- Field in WARDCAM for operator to enter value for dimensions at top and bottom of part for automatic taper angle calculation
- Option to run one pump at a time
Standard Equipment
- Footprint: 29.6′ x 20.8′
- One Carriage X-Y Cutting Area: 20′ x 13.1′
- Two Carriage X-Y Cutting Area: 20′ x 14.1′
- Software: WARDCAM, IGEMS
- Power Requirements: (Gantry Only) 230V, 30 amps, 3 Phase
- Air Requirements: 80 psi, 2 cfm
- Max Number of Z-Carriages: 6
- Bulk Feed Hopper: 1100 lb pressurized
- Drive Mechanism: Y-axis beam is ball screw driven. X-axis are helical rack and split pinion driven
- Linear Positional Accuracy: ± 0.010 ” per axis
- Repeatability: ± 0.005″ per axis
- Speed: 0.01 in/min – 500 in/min based on 230 volts
STOCK #JSWOD